GUI reference
R&S
®
ZNA
822User Manual 1178.6462.02 ─ 20
Deembed Two-Port (All Channels)
Reads and modifies the state of the built-in S-parameter correction that is available on
certain R&S®NRP-Z power sensors. See Application Note 1GP70 "Using S-Parame-
ters with R&S®NRP-Z Power Sensors" for background information. This Application
Note is available on the Rohde & Schwarz internet at http://www.rohde-schwarz.com/
appnotes/1GP70.
Remote command:
SYSTem:COMMunicate:RDEVice:PMETer<Pmtr>:SPCorrection[:STATe]
5.19.5 Generator tab
Allows you to set up and configure external generators and to enable error logging for
the current session.
Remote control via GPIB
The built-in GPIB interface can be used to control external devices. An additional USB-
to-IEC/IEEE adapter is only required in case you want to control the R&S ZNA via
GPIB at the same time..
5.19.5.1 Controls on the Generator tab
"Generators..." opens the "External Generators" Dialog; see Chapter 5.19.5.2, "Exter-
nal Generators dialog", on page 823.
Setup softtool
To Next Page
Loading...
