R&S ZNA67 - Cal Devices Tab

GUI reference
R&S
®
ZNA
558User Manual 1178.6462.02 ─ 20
Preferences
Allows you to configure the behavior of the validation diagrams and traces.
Unchecking "Auto Scale" prevents the traces from scaling as the measurement and/or
standard changes. Unchecking "Average On" turns off averaging.
Basic Mode
Switches to Basic mode
5.11.2 Cal Devices tab
Provides access to all functions for calibration kit management and cal unit characteri-
zation.
Background information
Refer to the following sections:
●
Chapter 4.5.2, "Calibration standards and calibration kits", on page 172
●
Chapter 4.5.5.3, "Characterization of calibration units", on page 183
The buttons in the "Cal Devices" tab open the following dialogs:
●
"Cal Connector Types...": See Chapter 5.11.2.1, "Cal Connector Types dialog",
on page 558
●
"Cal Kits...": See Chapter 5.11.2.2, "Calibration Kits dialog", on page 561
●
"Characterize Cal Unit...": See Chapter 5.11.2.3, "Characterize Cal Unit dialog",
on page 567
5.11.2.1 Cal Connector Types dialog
The "Cal Connector Types" dialog displays and modifies the list of available connector
types. Cal connector types must be selected in accordance with the connectors of the
measured DUT.
Access: Channel – [Cal] > "Cal Connector Types..."
Cal softtool