Command reference
R&S
®
ZNA
1113User Manual 1178.6462.02 ─ 20
CONFigure:CHANnel<Ch>:NAME:ID? <ChannelName>
Queries the channel number (numeric suffix) of a channel with known channel name. A
channel name must be assigned before (CONFigure:CHANnel<Ch>:NAME
<ChannelName>). CONFigure:CHANnel:CATalog? returns a list of all defined
channels with their names.
Suffix:
<Ch>
.
Channel number. This suffix is not relevant and may be omitted
(the command returns the actual channel number).
Query parameters:
<ChannelName> Channel name, e.g. 'Channel 4'.
Example: See CONFigure:CHANnel:CATalog?
Usage: Query only
Manual operation: See "Table Area" on page 390
CONFigure:CHANnel<Ch>:TRACe:REName
<TraceName>
Assigns a (new) name to the active trace in channel <Ch>.
Suffix:
<Ch>
.
Channel number
Setting parameters:
<TraceName> Trace name, e.g. 'Trace 4'.
Example:
*RST; :CONF:CHAN:TRAC:REN 'Testtrace_1'
Reset the analyzer to create a default trace in channel 1 and set
this trace as the active trace. Rename the trace 'Testtrace_1'.
CALC:PAR:SDEF 'Testtrace_2', 'S11'
Create a new trace which will become the active trace in chan-
nel no. 1.
CONF:TRAC:REN 'Testtrace_1', 'Testtrace_3'
Rename the first trace (which is currently not active) 'Test-
trace_3'.
Usage: Setting only
Manual operation: See "Table Area" on page 390
CONFigure:CHANnel<Ch>:TRACe:CATalog?
Returns the numbers and names of all traces in channel no. <Ch>. The response is a
string containing a comma-separated list of trace numbers and names; see example. If
all traces have been deleted the response is an empty string ("").
Tip: Use CONFigure:TRACe:CATalog? to query the traces in all channels of the
active recall set.
Suffix:
<Ch>
.
Channel number
SCPI command reference
To Next Page
Loading...
