R&S ZNA67 - Two Tone Group Dly Tab (Frequency-Converting DUT)

GUI reference
R&S
®
ZNA
370User Manual 1178.6462.02 ─ 20
This dialog offers the same settings as the Scalar Mixer Meas setup dialog. However,
for vector mixer measurements the LO ports must be controlled by the analyzer.
5.2.15 Two Tone Group Dly tab (frequency-converting DUT)
Sets up the channel for a two-tone group delay measurement (a.k.a. mixer group delay
measurement with embedded LO), and selects the measured quantities.
These measurements require software option R&S ZNA-K9. If this option is not instal-
led, the "Two Tone Group Dly" tab is not available.
Background information
Refer to Chapter 4.7.3.6, "Embedded LO mixer group delay measurements",
on page 246.
Meas softtool