R&S ZNA67 - Page 1312

Command reference
R&S
®
ZNA
1312User Manual 1178.6462.02 ─ 20
[SENSe:]CORRection:EDELay:VNETwork <Boolean>
Changes the position of the offset calculation in the "Offset Embed" calculation chain.
Parameters:
<Boolean> OFF (0)
The offset is calculated before de-/embedding (default).
ON (1)
The offset is calculated after de-/embedding.
*RST: 0
Manual operation: See "Offset > Calculate after De-/Embed." on page 697
[SENSe<Ch>:]CORRection:EWAVe[:STATe]
<Boolean>
Activates or deactivates the wave correction logic for wave quantities and ratios.
Suffix:
<Ch>
.
Channel number
Parameters:
<Boolean> *RST: ON (1)
Manual operation: See "Wave Correction" on page 316
[SENSe<Ch>:]CORRection:LOSS<PhyPt> <LossAtFrequency>
[SENSe<Ch>:]CORRection:LOSS<PhyPt>:SECond <LossAtFrequency>
These commands define the offset loss at the reference frequencies f
1
and f
2
.
The reference frequencies can be set using [SENSe<Ch>:]CORRection:
LOSS<PhyPt>:FREQuency and [SENSe<Ch>:]CORRection:LOSS<PhyPt>:
SECond:FREQuency.
Suffix:
<Ch>
.
Channel number
<PhyPt> Physical port number
Parameters:
<LossAtFrequency> Loss at reference frequency
Range: -200 dB to +200 dB
Increment: 0.001 dB
*RST: 0 dB
Default unit: dB
Manual operation: See "Loss at DC / Loss at 1st Freq / 1st Freq for Loss / Use 2nd
Freq / Loss at 2nd Freq / 2nd Freq for Loss" on page 653
[SENSe<Ch>:]CORRection:LOSS:AUTO <Activate>
Applies the Auto Length and Loss) function to the active trace of channel <Ch>.
SCPI command reference