1) to be trained, instructed or authorized to switch electric circuits and devi‐
ces safely on and off, to ground them and to mark them
2) to be trained or instructed to maintain and use adequate safety equipment
3) to attend a course of instruction in first aid
User
A user is a person installing, commissioning or using a product which has
been placed on the market.
2.2 Explanation of signal words and the Safety alert symbol
The Safety Instructions in the available application documentation contain
specific signal words (DANGER, WARNING, CAUTION or NOTICE) and,
where required, a safety alert symbol (in accordance with
ANSI Z535.6-2011).
The signal word is meant to draw the reader's attention to the safety instruc‐
tion and identifies the hazard severity.
The safety alert symbol (a triangle with an exclamation point), which pre‐
cedes the signal words DANGER, WARNING and CAUTION, is used to alert
the reader to personal injury hazards.
In case of non-compliance with this safety instruction, death or serious injury
will occur.
In case of non-compliance with this safety instruction, death or serious injury
could occur.
In case of non-compliance with this safety instruction, minor or moderate in‐
jury could occur.
In case of non-compliance with this safety instruction, property damage could
occur.
2.3 General Information
2.3.1 Using the Safety Instructions and Passing Them on to Others
Do not attempt to install and operate the components of the electric drive and
control system without first reading all documentation provided with the prod‐
uct. Read and understand these safety instructions and all user documenta‐
tion prior to working with these components. If you do not have the user doc‐
umentation for the components, contact your responsible Bosch Rexroth
sales partner. Ask for these documents to be sent immediately to the person
or persons responsible for the safe operation of the components.
Bosch Rexroth AG DOK-RCON02-FV*********-IB08-EN-P26/259
Rexroth Frequency Converter Fv
Safety Instructions for Electric Drives and Controls