Sam4s SPS-300 - Page 135

SAM4S SPS-300 Series Electronic Cash Register AU Service Mode Programming • 123
7. After a while, OK appear on the right side of “RAM (16M)”, then “Please Wait ….”
appears last on the display.
8. The display then shows 2-STATION PRINTER : ‘CASH’ Key 1-STATION
PRINTER : ‘CLEAR’.
For an SPS-320/325 (one printer station), press CLEAR
For an SPS-340/345 (two printer stations), press CASH
9. The display then shows AUTO CUT : ‘CASH’ Key NO CUT : ‘CLEAR’ Key.
If you want Auto Cutter to be enable, press CASH
If you want Auto Cutter to be disable, press CLEAR
NOTE: AUTO AUTTER can be enable/disable in PROGRAM MODE Æ SYSTEM
OPTION Æ pg 17.
AUTO CUT : ‘CASH’ Key
NO CUT : ‘CLEAR’ Key
2-STATION PRINTER : ‘CASH’ Key
1-STATION PRINTER : ‘CLEAR’ Key
RAM ALL CLEAR
← ← ← ←
RAM (16M) OK
Please Wait ....