Satec PM130 PLUS Series - Working with Tables; Working with Graphic Windows

Chapter 9 Viewing Files Viewing Options
PM130 PLUS Powermeter Series_Installation Operation and Manual 143
9.2.2 Working with Tables
Selecting Font and Grid
To change the table font or a type of the grid lines:
1. Click with right mouse button on the table, select Options and click on the Table tab.
2. Select the font type and size and how you wish the table grid to be shown.
3. Click OK.
Selecting Primary and Secondary Units
Voltages and currents can be displayed in primary or secondary units.
To change units, click on the table with the right mouse button, select Options, select the desired units for
voltages and currents, and then click OK.
Copying a Table
To copy the entire table, or its part, into the Clipboard or into another application such as Microsoft Excel
or Word:
1. Click on the data window with the right mouse button and choose Select All, or click on the upper-
left corner of the table (where the “No.” label is commonly displayed).
2. Click with the right mouse button on the window again and choose Copy, or click on the Copy
button on the PAS toolbar.
3. Run the application to which you want to copy data, position the cursor at the correct place.
4. Click the Paste button on the application's toolbar or select Paste from the Edit menu.
When copying, table columns are separated by a tab character.
Printing a Table
To check how your document appears on a printed page, select Print Preview from the File menu.
To print a table to a printer, click on the print button on the toolbar, select a printer and click OK.
9.2.3 Working with Graphic Windows
Selecting Channels
To select the channels you want to view on the screen, click on the graph window with the right mouse
button, select Channels..., check the channels you want displayed, and then click OK.
Checkboxes for channels that are not available in the present view are dimmed.
Selecting Primary and Secondary Units
Voltages and currents can be displayed in primary or secondary units.
To change units, click on the table with the right mouse button, select Options, select the desired units for
voltages and currents, and then click OK.
Selecting the Time Axis
In waveform views, the horizontal axis can be displayed either in absolute time with date and time stamps,
or in milliseconds relatively to the beginning of a waveform.
To change the time units, click on the waveform window with the right mouse button, select Options...,
click on the Axes tab, select the desired units, and then click OK.