Chapter 6 Device Control and Upgrading Resetting Accumulators, Maximum Values and Files
PM130 PLUS Powermeter Series_Installation Operation and Manual 119
Chapter 6 Device Control and Upgrading
This section describes operations on the meter you can perform from the front display or via PAS. To
access device control options from PAS, you should have your meter online.
6.1 Resetting Accumulators, Maximum Values and Files
Using the Front Display
Select the rst entry from the main menu. See Viewing and Changing Setup Options in Chapter 3 for
information on configuring parameters via the front display.
To reset the desired values:
1. Highlight the middle window by pressing briefly the SELECT button.
2. Select a reset entry by scrolling through the list with the UP and DOWN arrow buttons.
3. Press the SELECT button briefly to highlight the lower item.
4. Press and hold the ENTER button for 5 seconds.
5. Release the button.
6. The do entry is replaced with done showing the operation is complete.
Table 31 shows the reset options available from the front display.
Table 31: Front Display Reset Options
Clears all total energies
Clears all maximum demands
Clears power maximum demands
Clears ampere and volt maximum demands
Clears device diagnostics
To Next Page
Loading...
