Satec PM130 PLUS Series - Mechanical Installation; Panel Mounting

Chapter 2 Installation Mechanical Installation
PM130 PLUS Powermeter Series_Installation Operation and Manual 21
2.3 Mechanical Installation
Refer to the figures provided in this section to properly perform the mechanical installation.
Figure 2-1. Dimensions
2.3.1 Panel Mounting
To mount the meter in cutout (ANSI 4" round or DIN 92x92mm square cutout):
1. Position the meter in the cutout.
2. Affix the meter using washers and nuts. (Add short text on Panel Mounting, a heading should
always have text)
Figure 2-2. Mounting