PM130 PLUS Powermeter Series_Installation Operation and Manual 8
Quick Start Guide
This section can be used by a licensed electrician to install and perform basic PM130 PLUS setup. For
more detailed PM130 PLUS setup and use instructions, see the following chapters in this manual.
This quick start guide will assist you to have the unit running for the first time.
During the operation of the meter, hazardous voltages are present in the input terminals. Failure to observe
precautions can result in serious or even fatal injury, or damage to equipment.
For complete and accurate in-depth instructions, refer to the following chapters in this manual.
1. Installing the PM130 PLUS
Mounting the PM130 PLUS Unit
To mount the PM130 PLUS:
1. Position the PM130 PLUS unit in the square or round cutout. If two PLM130 PLUS are positioned
side by side, take care of proper interval between them.
2. Attach the PM130 PLUS unit using washers and nuts. Make sure that the unit is securely attached
into the wall or cabinet fixture.
To Next Page
Loading...
