Section 3: Operation and Configuration
Page 3-68 HR2 Series Operator Manual
3.17 DOWNLOAD MODE (Cont’d)
DOWNLOAD MODE
Menu Description
Writing download data.
The gauge shown on the lower portion of screen indicates writing status of
download data.
After writing the download font, it goes to FONT REGISTRY COMPLETED
screen.
After writing the download data, it goes to VERIFYING... screen.
Verifying download data.
The gauge shown on the lower portion of screen indicates verification status of
download data.
After verifying the download data, it goes to PROGRAM DOWNLOAD COM-
PLETED screen.
Completion of download.
Emitting three short beeps when program download is completed.
If downloading from INTERFACE, press FEED button will go back to DOWN-
LOAD READY screen.
If downloading from SD CARD, press FEED button will return to INTERFACE
SELECT screen.
Completion of font data registry.
Emitting three short beeps when font registry is completed.
Goes to DOWNLOAD READY screen automatically three seconds later.
Completion of font data deletion.
Emitting three short beeps when font delete is completed.
Goes to DOWNLOAD READY automatically three seconds later.
Selecting the item to be downloaded.
This screen displays only when INTERFACE SELECT is set to SD CARD.
FIRMWARE: Downloading “Firmware”, “Kanji font”, “Kanji outline font”.
KANJI FONT: Downloading “Kanji font”, “Kanji outline font”.
SEMBL: SEMBL program data
CONFIG: Printer configuration
FONT/LOGO: Font/ Logo data
ALL: All
The initial setting is FIRMWARE.
Reading in the download data.
The gauge shown on the lower portion of screen indicates data reception sta-
tus.
After receiving the data, it goes to WRITING… screen.
To Next Page
Loading...
