Sea-doo 2005 4-Tec models User Manual

Section04ENGINEMANAGEMENT(15034-TEC)
Subsection 02 (DIAGNOSTIC PROCEDURES)
RESPONSIBLE MODULE
FAULT
CODE
INFORMATION
CENTER
MPEM ECM
BEEPER
CODE
WARNING
LIGHT
MESSAGE
DISPLAYED
(INFO CTR)
FAULT
DETECTED
WHILE ENGINE
NOT RUNNING
FAULT
DETECTED
WHILE ENGINE
RUNNING
LIMP
HOME
MODE
NORMAL
OPERATION
RESUME
WHEN...
P1517
Compass out
of range
— — 15 Off SENSOR Y Y N N/A
Possible cause:
Damaged sensor, damaged circuit wires, damaged connector or damaged MPEM output pins.
Service action:
Check compass connection.
Connect or disable compass in setting page.
P1590 —
VTS Position
Sensor Circuit
– Out of Range
— 15 Off SENSOR — — N —
Possible cause:
Damaged sensor, damaged circuit wires, damaged connector or damaged MPEM output pins.
Service action:
Check for 24 to 167.5 ohms between system circuits 2-8 and 2-9.
Connect or disable VTS in setting page.
P1591 —
VTS Position
Sensor Circuit
– Low Voltage
— 15 Off SENSOR — — N —
Possible cause:
Damaged sensor, damaged circuit wires, damaged connector or damaged MPEM output pins.
Service action:
Check for 24 to 167.5 ohms between system circuits 2-8 and 2-9.
Connect or disable VTS in setting page.
P1592 —
VTS Position
Sensor Circuit
– High Voltage
— 15 Off SENSOR — — N —
Possible cause:
Damaged sensor, damaged circuit wires, damaged connector or damaged MPEM output pins.
Service action:
Check for 24 to 167.5 ohms between system circuits 2-8 and 2-9.
Connect or disable VTS in setting page.
P1593 — VTS Malfunction — 15 Off SENSOR — — N —
Possible cause:
Mechanical failure on VTS or VTS mechanically immobilized.
Service action:
Check VTS rod.
P1607 — MPEM FAULT — 15 N/A — — — N —
Possible cause:
Damaged MPEM.
Service action:
No service action available for fault P1607.
smr2005-012 99
www.SeaDooManuals.net

Sea-doo 2005 4-Tec models Specifications

General

Displacement	1494 cc
Fuel Type	Unleaded gasoline
Engine Type	4-TEC
Cooling System	Closed-loop cooling
Seating Capacity	3
Width	48 inches (122 cm)
Fuel Capacity	15.9 US gallons