EasyManuals Logo

Sea-doo 2005 4-Tec models User Manual

Sea-doo 2005 4-Tec models
314 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
INTRODUCTION
ABBREVIATION DESCRIPTION
RAVE
Rotax Adjustable Variable Exhaust
RFI
Rotax Fuel Injection
RPM
Revolution Per Minute
Sc
Supercharger
STD Standard
TBD
To Be Determined
TDC Top Dead Center
TPS
Throttle Position Sensor
VDC Volt Direct Current
VCK
Vehicle Communication Kit
Vdc Volt Direct Current
VTS
Variable Trim System
WTS Water Temperature Sensor
ILLUSTRATIONS AND
PROCEDURES
The illustrations show the typical construction of
the different assemblies and, in all cases, may not
reproduce the full detail or exact shape of the parts
shown, however, they represent parts which have
the same or a similar function.
CAUTION: These watercraft are designed with
parts dimensioned mostly in the metric sys-
tem. However some components may be from
the imperial system. When replacing fasten-
ers, make sure to use only those recommended
by BRP.
As many of the procedures in this manual are inter-
related, we suggest, that before undertaking any
task, you read and thoroughly understand the en-
tire section or subsection in which the procedure
is contained.
A number of procedures throughout the book re-
quire the use of special tools. Before undertaking
any procedure, be sure that you have on hand all
the tools required, or approved equivalents.
smr2005-002 IX
www.SeaDooManuals.net

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sea-doo 2005 4-Tec models and is the answer not in the manual?

Sea-doo 2005 4-Tec models Specifications

General IconGeneral
Displacement1494 cc
Fuel TypeUnleaded gasoline
Engine Type4-TEC
Cooling SystemClosed-loop cooling
Seating Capacity3
Width48 inches (122 cm)
Fuel Capacity15.9 US gallons

Related product manuals