Sea-doo 2005 4-Tec models User Manual

Section 09 HULL/BODY
Subsection 01 (ADJUSTMENT AND REPAIR)
F07L08A
A
2
1
TYPICAL — FRONT SEAT
1. Lock pin
2. Adjustment nut (Loctite 243). Torque to 8 N•m(71lbf•
in)
A. 33 ± 1 mm (1-35/64 ± 3/64 in)
F06L03A
A
1
2
TYPICAL — REAR SEAT
1. Lock pin
2. Adjustment nut (apply Loctite 243). Torque to 5 N•m(44lbf•
in)
A. 35 ± 1 mm (1-5/16 ± 3/64 in)
RXT Models
A
2
F16L0TA
1
1. Lock pin
2. Adjustment nut (apply Loctite 243). Torque to 8 N•m(71lbf•
in)
A. 36 ± 1 mm (1-35/64 ± 3/64 in)
STORAGE COMPARTMENT
INNER SHELL
Removal and Installation
GTX Series, Wake and RXT Models
To remove inner shell, proceed as follows:
CAUTION: Failure to follow this order may lead
to damaging inner plastic studs.
– Open storage cover.
– Remove access panel.
– Disconnect multifunction connector.
264 smr2005-024
www.SeaDooManuals.net

Sea-doo 2005 4-Tec models Specifications

General

Displacement	1494 cc
Fuel Type	Unleaded gasoline
Engine Type	4-TEC
Cooling System	Closed-loop cooling
Seating Capacity	3
Width	48 inches (122 cm)
Fuel Capacity	15.9 US gallons