Section 11 ELECTRICAL CONNECTORS AND WIRING DIAGRAMS
Subsection 01 (ELECTRICAL CONNECTORS)
Terminal Identification
AMP Connectors of MPEM
26
25
24
23
15
8
16
9
1
F04H6RA
AMP Connectors of Wiring Harness
F04H6GA
9
ECM CONNECTORS
There are two ECM connectors used on the 4-TEC
models and they are connected on the ECM. The
engine harness female connector is connected on
the module male connector “A” and the water-
craft system control harness female connector is
connected to the module male connector “B”.
The ECM connectors have 41 pins.
1
F18Z02A
2
3
1. ECM
2. A connector (engine harness)
3. B connector (watercraft harness)
For probing techniques and tool, refer to ENGINE
MANAGEMENT.
CAUTION: Do not disconnect the ECM connec-
tors needlessly. They are not designed to be
disconnected/reconnected frequently.
Terminal Removal
Unlock the connector cover by pushing in the tabs
on top of the connector with a flat screwdriver to
be able to flip the top cover up.
1
F18Z0RA
1. Push in tab
Lift the cover by pushing it forward.
302 smr2005-026
To Next Page
Loading...
