Sea-doo 2005 4-Tec models User Manual

Section 03 ENGINE SYSTEM
Subsection 02 (LUBRICATION SYSTEM)
LUBRICATION SYSTEM
SERVICE TOOLS
Description Part Number Page
suction pump........................................................................
529 035 880 ........................................... 35
SERVICE PRODUCTS
Description Part Number Page
pulley flange cleaner.............................................................
413 711 809 ........................................... 35
GENERAL
Prior to changing the oil, ensure vehicle is on a
level surface.
Oil and oil filter must be replaced at the same
time. Oil change and oil filter replacement should
be done with a warm engine.

WARNING
The engine oil can be very hot. Wait until en-
gine oil is warm.
Dispose oil and filter as per your local environmen-
tal regulations.
OIL LEVEL VERIFICATION
CAUTION: Check level frequently and refill if
necessary. Do not overfill - it would make the
engine smoke and reduce its power. Operating
the engine with an improper level may severely
damage engine. Wipe off any spillage.
F18D04A
1
1. Dipstick
smr2005-007 en 33
www.SeaDooManuals.net

Sea-doo 2005 4-Tec models Specifications

General

Displacement	1494 cc
Fuel Type	Unleaded gasoline
Engine Type	4-TEC
Cooling System	Closed-loop cooling
Seating Capacity	3
Width	48 inches (122 cm)
Fuel Capacity	15.9 US gallons