Sea-doo 2005 4-Tec models User Manual

Section 09 HULL/BODY
Subsection 01 (ADJUSTMENT AND REPAIR)
GENERAL
Verify hinges condition and latching mechanisms
condition and operation. Replace any damaged
components.
When applying threadlocker Loctite products
(anaerobic products), pay attention so that it does
not come in contact with ABS plastic parts (paint-
ed parts). It could lead to plastic cracks or other
damage.
GLOVE BOX
Removal
All Models except RXP
Lift the glove box top cover.
Gently push on both rear tabs while lifting out rear
of glove box compartment.
F18L3MA
1
1. Push tabs
Pull the glove box out of body.
RXP Models
Place shift lever in forward position.
Remove seat.
Pull dart out. See illustration.
F19L16A
1
1. Pull dart out
Carefully pull the side molded part to release the
glove box. Pulling too much might lead to damag-
ing the part.
F19L17A
RELEASE SIDE MOLDED PART FROM GLOVE BOX
Slightly lift glove box to free it.
Proceedwiththeothersidethesamewaytofi-
nally pull glove box out.
262 smr2005-024
www.SeaDooManuals.net

Sea-doo 2005 4-Tec models Specifications

General

Displacement	1494 cc
Fuel Type	Unleaded gasoline
Engine Type	4-TEC
Cooling System	Closed-loop cooling
Seating Capacity	3
Width	48 inches (122 cm)
Fuel Capacity	15.9 US gallons