Section01MAINTENANCE
Subsection 04 (SPECIAL PROCEDURES)
SPECIAL PROCEDURES
SERVICE TOOLS
Description Part Number Page
large hose pincher ................................................................
529 032 500
........................................... 11
oil pump cover fitting............................................................
293 710 037 ........................................... 13
pump ....................................................................................
529 035 880 ........................................... 13
SERVICE PRODUCTS
Description Part Number Page
Loctite 243 (blue)..................................................................
293 800 060 ........................................... 13
pulley flange cleaner.............................................................
413 711 809 ........................................... 13
TOWING THE WATERCRAFT
IN WATER
Special precautions should be taken when towing
a Sea-Doo watercraft in water.
Maximum recommended towing speed is
24 km/h (15 MPH).
When towing your watercraft in water, pinch the
water supply hose from the jet pump housing to
theenginewithalargehosepincher(P/N529032
500).
529 032 500
This will prevent the exhaust cooling system from
fillingwhichmayleadtowaterbeinginjectedin-
to and filling the exhaust system and the engine.
Withoutthe engine running there isn't any exhaust
pressure to carry the water out the exhaust outlet.
CAUTION: Failure to do this may result in dam-
age to the engine. If you must tow a strand-
ed watercraft in water and do not have a hose
pincher be sure to stay well below the maxi-
mum towing speed of 24 km/h (15 MPH).
Snugly install the hose pincher on the water sup-
ply hose as shown in the following illustrations.
NOTE: Pinch the hose with the red tape (if so
equipped).
smr2005-005 11
To Next Page
Loading...
