Section07PROPULSION
Subsection 04 (VARIABLE TRIM SYSTEM)
Apply Loctite 243 (blue) (P/N 293 800 060) to nut
no. 4.
Install nut with sealing washer and torque to
7N•m(62lbf•in) using the VTS socket tool
(P/N 295 000 133).
Apply synthetic grease (P/N 293 550 010) to slid-
ing shaft.
Rubber Boot and Clamps
Install rubber boot no. 3 over sliding shaft and se-
cure with clamps.
VTS Rod
Install rubber boot no. 3, over sliding shaft and
secure with clamps.
SecuretheVTSrodontotheslidingshaftendus-
ing bolt no. 13 and nut no. 14. Torque nut to
4N•m(35lbf•in).
ADJUSTMENT
No adjustment is required.
smr2005-028 225
To Next Page