Sea-doo 2005 4-Tec models User Manual

Section 01 MAINTENANCE
Subsection 03 (STORAGE PROCEDURES)
CHECKLIST
OPERATION ✔
Verify jet pump grease.
Verify fuel system.
Add Bombardier fuel stabilizer.
Fill up fuel tank.
Change engine oil and filter.
Check engine drain hose(s).
Flush exhaust cooling system.
Replace antifreeze. Check solution
concentration in the cooling system (in cool
regions).
Lubricate the engine.
Lubricate throttle body.
Add antifreeze into intercooler and exhaust
manifold (where temperatures are below
freezing).
Remove, clean and store the battery.
Clean the bilge.
Wash the body.
Spray BOMBARDIER LUBE lubricant (P/N 293
600 016) over all metallic components in engine
compartment and in throttle cable.
Apply the anticorrosion coating (P/N 219 700
304) on drive shaft.
Partially lift the seat and the seat extension.
10 smr2005-004
www.SeaDooManuals.net

Sea-doo 2005 4-Tec models Specifications

General

Displacement	1494 cc
Fuel Type	Unleaded gasoline
Engine Type	4-TEC
Cooling System	Closed-loop cooling
Seating Capacity	3
Width	48 inches (122 cm)
Fuel Capacity	15.9 US gallons