Sea-doo 2005 4-Tec models User Manual

Section 03 ENGINE SYSTEM
Subsection 03 (COOLING SYSTEM)
2
F18E1GA
13
TYPICAL
1. Exhaust pipe
2. Outlet holes of exhaust pipe
3. Muffler
Bleeding of the exhaust system is accomplished
by the bleed hose located at the upper most point
of the circuit of the exhaust pipe.
Water exits exhaust pipe through holes at the end
of the water packet and mixes with exhaust gas
in the muffler.
Water is expulsed from mufflers then through the
exhaust outlet in transom area.
Intercooler
Supercharged Intercooled Engine
For the intercooler servicing, refer to the 1503
4-TEC ENGINE SHOP MANUAL.
Clamp Replacement
To cut or secure Oetiker clamps of cooling system
hoses, use the pliers Oetiker 1099 (P/N 295 000
070).
1
F01B2KA
2
1. Cutting clamp
2. Securing clamp
CARE
For flushing and winterization procedures of the
opened loop cooling system, refer to STORAGE.
When servicing the hull, rotate watercraft either
way (seen from the rear) maximum to 90°.
F18L13A
46 smr2005-008
www.SeaDooManuals.net

Sea-doo 2005 4-Tec models Specifications

General

Displacement	1494 cc
Fuel Type	Unleaded gasoline
Engine Type	4-TEC
Cooling System	Closed-loop cooling
Seating Capacity	3
Width	48 inches (122 cm)
Fuel Capacity	15.9 US gallons