Section04ENGINEMANAGEMENT(15034-TEC)
Subsection 02 (DIAGNOSTIC PROCEDURES)
F18H0XA
kW2000
MPEM AND ECM ARE CONNECTED
Number 1 means that 1 “ECU” is connected (ei-
ther MPEM or ECM). Therefore, there is a prob-
lem. Check fuses and connections.
F18H0WA
kW2000
ONLY ONE “ECU” IS WORKING. THERE IS A PROBLEM
If an “X” is shown, the safety lanyard is not in-
stalled on its post or there is a problem with both
“ECUs”. Ensure VCK is working properly and
check connections on VCK and watercraft.
VCK Supply
The VCK (MPI box) can use the watercraft power
for its supply.
The safety lanyard must be connected in order to
use the watercraft as a power source.
If watercraft power is used, every time the safety
lanyard is taken off the DESS post, the kW2000
protocol will have to be re-activated.
Changes in ECM
Anytime a change is brought in ECM through
B.U.D.S., there will be an “EMS Tracking” mes-
sage that will say “Remove key from vehicle”.
When this occurs, remove the safety lanyard from
its post and wait until the message disappears
(it lasts approximately 15 seconds after lanyard
removal).
106 smr2005-012
To Next Page
Loading...
