Sea-doo 2005 4-Tec models User Manual

Section 07 PROPULSION
Subsection 02 (DRIVE SYSTEM)
3
F18I0JA
2
1
WRONG INSTALLATION
1. PTO seal assembly
2. Telltale groove visible
3. Inner sleeve NOT flush with outer circumference
If drive shaft does not enter into the PTO seal,
check engine alignment.
Install drive shaft holder tool. Refer to the follow-
ing table to use the appropriate tool according to
the model.
MODEL TOOL
ALL
Drive shaft holder
(P/N 529 035 986)
F18B03A
Install drive shaft/floating ring tool as shown. En-
sure PTO seal support is still in place.
Refer to the following table to use the appropriate
tool according to the model.
MODEL TOOL
GTX 4-TEC Limited,
RXP and RXT
Drive shaft/floating ring
tool (P/N 529 035 987)
GTX 4-TEC, Wake
and GTX 4-TEC
Supercharged
Drive shaft/floating ring
tool (P/N 529 035 841)
Push floating ring rearwards and install circlip.
1
F18I0NA
TYPICAL
1. Largest opening on through-hull fitting side
F18C02A
4
3
2
1
TYPICAL
1. Largest opening
2. Floating ring
3. PTO seal support tool
4. Install circlip
Remove drive shaft/floating ring tool, drive shaft
holder then PTO seal support.
NOTE: Pushing boot no. 10 rearwards will ease
removal of PTO seal support tool.
212 smr2005-020
www.SeaDooManuals.net

Sea-doo 2005 4-Tec models Specifications

General

Displacement	1494 cc
Fuel Type	Unleaded gasoline
Engine Type	4-TEC
Cooling System	Closed-loop cooling
Seating Capacity	3
Width	48 inches (122 cm)
Fuel Capacity	15.9 US gallons