Section 03 ENGINE SYSTEM
Subsection 04 (EXHAUST SYSTEM)
Inspection
Inspect parts condition paying attention for cracks
or other damage. Check hose. Replace any de-
fective part.
Installation
Installation is essentially the reverse of the re-
moval procedures. However, pay particular atten-
tion to the following.
Apply Loctite silicone sealant (clear) (P/N 293 800
086) on the gasket no. 14 to seal the bilge.
Test the bilge for water leaks.
smr2005-009 57
To Next Page
Loading...
