Section04ENGINEMANAGEMENT(15034-TEC)
Subsection 02 (DIAGNOSTIC PROCEDURES)
– Refer to COMPONENT INSPECTION, RE-
PLACEMENT AND ADJUSTMENT section for
procedures.
Terminology
Some documents or softwares use technical
terms that may be different from the one used in
this manual. The following table will help to find
the equivalence.
TERMS USED IN
THIS MANUAL
TERMS USED IN
OTHER DOCUMENTS
SOFTWARES
Camshaft Cam
Communication link CAN
Crankshaft Crank
CTS
(Coolant Temperature
Sensor)
WTS
(Water Temperature Sensor)
ECM – ECU
– Module
EGTS
(Exhaust Gas
Temperature sensor)
ETS
(Exhaust Temperature
Sensor)
Idle bypass valve – DLA
(Digital Linear Actuator)
– Idle actuator
– Idle valve
Information center
Cluster
MAPS
(Manifold Air Pressure
Sensor)
APS
(Air Pressure Sensor)
or
(Atmospheric Pressure
Sensor)
MATS
(Manifold Air
Temperature Sensor)
ATS
(Air Temperature Sensor)
or
(Intake manifold
Temperature Sensor)
Oil separator Oil tank
OSPS
(Oil Separator Pressure
Switch)
OTPS
(Oil Tank Pressure Switch)
Safety lanyard – DESS key
– key
TOPS valve
(Tip-Over Protection
System)
– Blow-by valve
– BBV
80 smr2005-012
To Next Page