SICK FLOWSIC100

118 FLOWSIC100 · Operating Instructions · 8012513/YSA5/V2-1/2016-07 · © SICK Engineering GmbH
Start-up and Parameter Settings
Subject to change without notice
 Enter the IP address of the device or the IP address range when several devices are
used (  p. 118, Fig. 88). The IP addresses shown are exemplary.
 Click “OK”.
Fig. 88 Connection settings for connection via Ethernet (example)
5 Click “Next”.
6 When devices are connected via serial connections (COM ports), select the COM ports
used and click “Next”.
 If you are not sure which COM ports are used, select all COM ports.
Fig. 89 Selecting COM ports
7 To save the search settings, enter a name and click “Finish”.
SOPAS ET starts the device search.
The devices found are displayed in the “Device search” area when device search is
finished (  p. 122, Fig. 96).
NOTICE:
The MCU(P) is connected via USB to the laptop/PC.
A serial interface (COM port) is simulated via which the connection is made.