SICK S3000

Chapter 11 Operating instructions
S3000
136 © SICK AG • Industrial Safety Systems • Germany • All rights reserved 8009942/WK81/2012-11-28
Subject to change without notice
Diagnostics
Display Possible cause Rectification of the error
 Object in the first
protective field of the
simultaneous field set
or
Surrounding contour
27)
changed
No error
 Object in the second
protective field of the
simultaneous field set
or
Surrounding contour
2
7)
changed
No error
Indication of protective field and warning field infringements in the triple field mode
 Object in
protective field
No error
 Object in
warning field 1
No error
 Object in
warning field 2
No error
Show for all field modes
 Initialization of the
device
Or
Waiting for the end of
the initialization of a
second device
connected to the EFI
 The display goes out automatically when the
S3000 has been initialized and/or the
connection to the second device has been
made.
If the display  does not go off:
 Check whether the partner device is in
operation.
 Check the wiring.
If no partner device is connected:
 Check the system configuration with the aid
of the CDS. Transfer the corrected
configuration to the S3000 again.