Sicma TR80 - Replacement of Rubber Bands

Maintenance
6.10.8 Replacement of rubber bands
If a rubber band is excessively worn, it must be replaced:
A) Safely stop the machine. (*).
B) Remove the screws (1), nuts (4) and washers (5) that secure the rubber
band (2) to the rubber jaw (3).
C) Replace the rubber band (2) with a new one.
D) Insert and tighten the screws (1), nuts (4) and washers (5) removed
earlier to secure the new band (2) to the jaw (3).
E) Tighten the screws (1).
5
1
2
4 53
(*) See par. “5.7” pag. 99
Figure 76
133
SICMA S.r.l.