Maintenance
6.6.5 Replace hydraulic oil
To replace the hydraulic oil inside the tank, proceed as follows:
A) Park the machine on level, solid and firm ground.
B) Safely stop the machine. (*).
C) Loosen/remove tank cap (3) to ensure the air intake.
D) Place a container of suitable capacity under the drain plug (1) located
on the bottom of the tank
E) Then loosen and remove the cap (1).
NOTE
Alternatively, the hydraulic oil can be removed from the machine’s reservoir
by suction.
F) Let the oil drain completely.
G) At the end of the operation, close the cap (1) carefully cleaning the
surrounding area.
3
1
(*) See par. “5.7” pag. 99
Figure 62
115
SICMA S.r.l.
To Next Page
Loading...