Sicma TR80 - Machine Start-Up

Machine use
• Make sure that the remote control batteries are fully charged by means
of the LED indicators placed on it.
5.4.2 Machine start-up
The machine in transport configuration, coupled to the tractor, will be brought
up to the processing area.
Once the work point has been reached, before proceeding with starting the
machine, check that:
- the controls of the remote control are in the neutral position;
- all unauthorized persons are out of the machine's range;
- the remote control battery is charged;
- before energizing electrical cables or electrical parts, make sure they
are correctly connected.
Proceed as follows to start the machine:
DANGER
Before starting the machine's engine, sound the tractor horn repeatedly to
warn all persons within the machine's operating range to move away.
• Start the tractor to which the machine is connected.
• Using the tractor controls, engage the power take-off (PTO 540 rpm).
• Activate the auxiliary hydraulic circuit (quick couplings) of the tractor (if
provided) and the 12 Volt electrical socket (of the tractor, if necessary).
• Operate the remote control (*).
• At this point the machine is ready to function.
• Check the proper operation of all safety devices on the machine.
The pre-operational check consists of a visual inspection performed by the
operator before each work shift. It must be performed on the machine to
check for anomalies before the operator proceeds to test the functions.
It also serves to determine whether routine maintenance procedures are
necessary.
DANGER
If even one check fails, do not start work, stop the machine and repair the
fault.
WARNING
The operator is responsible for performing pre-operational checks and
routine maintenance.
For the safety of the operator, other people and for maximum efficiency, carry
out a general check of the machine:
• Make sure you have enough fuel (tractor) for sufficient range to avoid
the risk of a sudden stop.
• Thoroughly clean the instruments and plates.
• Check that the machine is perfectly coupled to the tractor and that all
its parts are in the intended position and solidly locked.
• Check that the connecting pins between the tractor and the machine
are in perfect condition. In case of wear, they must be replaced before
using the machine.
• Check the proper operation of all safety devices on the machine.
• Check the conditions of the electrical power cord.
• Check the hydraulic system for oil leaks and the correct level, restoring
it if necessary.
• Visually inspect the entire machine for cracks in welds or structural
components and for dents or damage to the machine.
• Check that pins, joints and bolts are properly tightened and in the
correct position.
• Check tire inflation pressure.
• Check for cuts or breaks in the tarpaulin highlighted by rustication.
DANGER
The explosion of a tyre may provoke severe damages to the entire machine;
do not use the machine whit damaged, deflate or worn tyres.
(*) See par. “5.6.2” pag. 96
91
SICMA S.r.l.