Machine use
5.6.1 Machine start and positioning
ATTENTION
At the first daily start-up, perform all the pre-operational checks indicated in
paragraph “5.4.1 (Daily) Preventive checks” pag. 90.
In any case, at every start-up, carry out a general visual check of the entire
machine (evident deformations or anomalies in the structure and layout of
the machine's parts and controls, in the protections, etc.)
After starting the machine (See par. “5.4.2” pag. 91), make sure that all
the organs are in optimal position, then proceed as follows:
A) Release the tractor parking break.
B) Reverse to bring the machine near the shaft identified by the vibration.
C) Apply the tractor parking brake and get out of the driver's seat.
Figure 55
95
SICMA S.r.l.
To Next Page
Loading...