Machine transport and handling
• Act on the manipulators (3) and (4) of the radio control to lower the
arm of the machine and place the vibrating head on the platform of
the means of transport. If necessary, arrange a support on the platform
to support the vibrating head.
• Turn off the remote control by turning the selector (battery switch)
counterclockwise.
• Ensure that the overall dimensions are within the permissible limits.
• Stop the tractor safely by applying the parking brake and remove the
keys from the ignition switch.
• Disconnect the machine from it, sequentially removing the electrical
connection, the hydraulic hoses from the quick couplings, the cardan
shaft and the couplings from the 3-point system (*).
• Start the tractor to move it away from the loading bed of the transport
vehicle; always proceed at low speed, avoiding sudden movements
and sudden accelerations.
• Carry out the procedures for anchoring the machine as indicated in
paragraph “2.1.1 Warnings for coupling/uncoupling the machine”
pag. 13.
3
4
(*) See par. “5.2” pag. 80
Figure 28
59
SICMA S.r.l.
To Next Page
Loading...