System Overview
Operating and Display Elements
AXIOM Iconos R200 AXD3-340.620.13.01.02 41 / 44
Changing the bulb of the laser light localizer
As soon as the lamp brightness decreases, this symbol is shown in the collimator
display. It recommends to change the bulb.
Although you can continue working with less brightness, we recommend to
change the bulb as soon as possible.
To change the bulb proceed as follows:
◆ Switch the system off at the generator ON/OFF console.
◆ If necessary, turn the collimator to get better access.
➩ Refer to the description in the according system Operator Manual.
Lamp cover at the backside of the collimator
◆ Loosen the 3 screws on the lamp cover using a conventional slotted screw-
driver.
◆ Remove the lamp cover.
Heat shield
(1)
(2)
To Next Page
Loading...
