Connectivity and communication with 'Station'
Connecting Cerberus Remote
7
105 |
Building Technologies
7.3 Connecting Cerberus Remote
w Enabling for viewing and / or operating the ↑ 'Station' with Cerberus-Remote is
granted.
w The PC is connected to the ↑ 'Site'.
1. Select the 'Cerberus-Remote' task card.
2. Select 'Cerberus-Remote' > 'Connect' from the menu bar.
a The selection window for the connection is displayed.
3. Select the connection and confirm with 'OK'.
a The 'Connect Cerberus-Remote' window opens.
4. Select the 'Station' that you wish to display and/or operate and enter a valid
PIN.
5. Click on 'OK'.
a The connection is established.
Connect from the Favorites list with 'Station'
w Enabling for viewing and/or operating the 'Station' with Cerberus-Remote is
granted.
w The PC is connected to the 'Site'.
1. Select the 'Cerberus-Remote' task card.
2. Select 'Cerberus-Remote' > 'Connect to favorite' from the menu bar.
3. Select the desired 'Station' from the list.
a The connection is established.
You will find a description of enabling for viewing and/or operating with
Remote in document A6V10211076. See chapter 'Applicable documents'.
You can use the presettings to cause
automatically with the most recently connected 'Station' when you open the task
card 'Cerberus-Remote'.
See also
2 Cerberus Remote [➙ 57]
2 Cerberus Remote [➙ 38]
To Next Page
Loading...
