Siemens FS720 - Creating a Station

Program operation
Creating a station
6
67 |
412
Building Technologies
A6V10210424_j_en_
--
Fire Safety
2018
-
08
-
29
6.2 Creating a station
If you are creating a ↑ 'Station' for the first time, decide whether the 'Station' will be
networked or if it is going be a ↑ 'Standalone station'.
You can create 'Stations' with the following network properties:
● 'Standalone station', not networked*
● 'SAFEDLINK station'
● 'Ethernet station'
* Please observe the information concerning BACnet configuration here: BACnet
UDP port
When a 'SAFEDLINK station' is created, it may already be assigned to a specific
↑ SAFEDLINK sub-net.
Additional ↑ 'Stations' can only be created as networked.
Figure 16: Window to creating a 'station'
Creating 'Station'
w A ↑ 'Site' has been created.
1. Open the 'New station' window. This can be done in the following ways:
– Click on the symbol in the toolbar.
– Select 'Edit' > 'New station' from the menu bar.
– Right-click in the tree view and select 'New station' in the context menu.
a The 'New station' window opens above the table.
2. Select a 'Station' from the 'Type:' selection list.
3. Select a template from the 'Template:' selection list.
4. Select the corresponding network for networked 'Stations'.
5. Select the number of new 'Stations' in the 'Amount:' field.
6. Click on 'Add'.
a The 'Station' is created.
Networked 'Stations'
Details for creation of networked 'Stations' can be found in chapter 'Creating
networked 'Stations''.