Siemens FS720 - Cerberus Remote

Software administration
Pre
-
settings
4
38 | 412
Building Technologies
A6V10210424_j_en_
--
Fire Safety
2018
-
08
-
29
4.5.2 Cerberus Remote
Figure 1: Settings for Cerberus Remote
The following can be set in the 'Cerberus-Remote' view:
● 'Connect Cerberus-Remote automatically to the last connected station when
opening Cerberus-Remote taskcard': If the checkbox is activated, then
Cerberus-Remote will be connected automatically when you open the
'Cerberus-Remote' task card. The connection is made with the most recently
connected ↑ 'Station'. The connection must be set up once manually after
Cerberus-Engineering-Tool has started.
● 'Cerberus-Remote favorite list': In this list, you can save frequently used
'Stations' with the connection details. The 'Stations' in the Favorites list are
listed in the 'Cerberus-Remote' > 'Connect to favorite' menu. This makes it
possible for you Cerberus-Remote to connect quickly and easily with 'Stations'.
● 'Add new favorite': Adding new 'Station' to the Favorites list.
● 'Edit selected favorite': Edit 'Station' in the Favorites list.
● 'Delete selected favorite': Delete 'Station' from the Favorites list.
Adding new 'Station' to the Favorites list
1. Click on 'Add new favorite'.
a The 'Add new favorite station' window opens.
2. Enter the name, IP address, 'Station' ID, and PIN of the 'Station''.
3. Click on 'OK'.
a The 'Station' is added to the Favorites list.
a In the task card 'Cerberus-Remote', the 'Station' are listed in the 'Cerberus-
Remote' > 'Connect to favorite' menu.