Siemens FS720 - Configuring an Audio Sequence

'Control' task card
Evac control group
12
226 | 412
Building Technologies
A6V10210424_j_en_
--
Fire Safety
2018
-
08
-
29
12.4.4 Configuring an audio sequence
w A 'Phased voice evac control' element or a 'Prioritized voice evac control'
element is created within a 'Evac control group' element.
1. Under the element in question, mark the 'Causes' element whose 'Audio
sequence' you wish to configure.
2. Configure the parameters in the 'Audio sequence' tab.
You will find information on the parameters in a table below. Link [➙ 227]
3. Switch to the task card 'Operation'.
4. Mark 'Site' > 'Global system configuration' > 'Global behaviour'
5. Configure the parameters relevant to voice messages in the 'Details' tab. You
will find information about the parameters in the chapter 'System behavior
[➙ 255]'.
6. Save the configuration file with 'File' > 'Save'.