Siemens FS720 - Basic Settings

'Operation' task c
ard
Person Machine Interface (PMI)
13
260 | 412
Building Technologies
A6V10210424_j_en_
--
Fire Safety
2018
-
08
-
29
13.2.1 Basic settings
You will find the basic settings for the ↑ Person Machine Interface in the detail
editor of the 'PMI' element.
'Overview' tab
The following properties can be set in the 'Overview' tab:
'Logout timeout'
This setting specifies the length of time after which the ↑ Person Machine Interface
of the ↑ 'Station' automatically switches back to 'Default access level' if no key is
pressed.
'Operation timeout 'ALARM''
This setting specifies the length of time after which the ↑ Person Machine Interface
of the ↑ 'Station' automatically switches from the menu display to the message
display if no key is pressed. This time-out is used if ALARM events are present.
'Operation timeout 'NO alarm''
This setting specifies the length of time after which the ↑ Person Machine Interface
of the ↑ 'Station' automatically switches from the menu display to the message
display if no key is pressed. This time-out is used if no ALARM events are present.
The time outs are only used if the corresponding '
Enabled
' checkbox is activated.
'Default access level'
This setting specifies the standard access level of the ↑ 'Station'. If the 'Station' has
a key switch, then this setting is for the 'off' position.
'Access level 'key switch''
If the ↑ 'Station' has a key switch, then this setting specifies the access level in the
'on' position.
'Details' tab
The following properties can be set in the 'Details' tab: