Siemens FS720 - 6 Program Operation; Creating a Site; Loading an Existing Site

Program operation
Creating a site
6
62 | 412
Building Technologies
A6V10210424_j_en_
--
Fire Safety
2018
-
08
-
29
6 Program operation
It is possible that
Cerberus
-
Engineering
-
Tool
will start to run slightly slower over
time, e.g., after extensive copying / pasting or when creating / deleting a large
number of ↑ 'Stations'. If this happens, we would recommend reloading the
↑ 'Site'. Cerberus-Engineering-Tool will then work normally again.
6.1 Creating a site
The following possibilities are open to you when you create a 'Site':
● Load existing 'Site' in Cerberus-Engineering-Tool
● Create 'Site' based on an existing configuration
● Create new 'Site'
You will find information on the procedures in the following chapters.
6.1.1 Loading an existing 'site'
NOTICE
Unauthorized characters in the
↑
'
Site
' name or in the path: <
>
/
\
|
:
?
*
"
%
#
'Site' may not be able to be saved or loaded.
● Do not use any of the following characters in the 'Site' name or in the path:
< > /
\
| : ? * " % #
The progress of the '
Upload from station(s)
' is shown in the status bar.
If communication between the PC and 'Station' is interrupted, a message
indicating that the upload has been aborted is displayed.
w The 'Site' already contains a configuration.
w The PC is connected to a 'Station'.
1. Select 'File' > 'New site' from the menu bar or click on the following button in
the toolbar:
a The first 'Create new site' window opens.
2. Select the 'Upload from station(s)' option.
3. Click on 'Next'.
a The configuration of the 'Site' is loaded in Cerberus-Engineering-Tool.
a The second 'Create new site' window opens.
4. Enter the required information, e.g. the 'Site' name.
5. Click on 'Create'.
a The 'Site' is created in Cerberus-Engineering-Tool.
See also
2 Editing 'site' properties [➙ 65]