Connectivity and communication with 'Station'
7
106 | 412
7.4 Load data to the station
Data is loaded from Cerberus-Engineering-Tool to the ↑ 'Station' when the
following commands are performed.
● 'Initialize station'
● 'Download site'
If you use more than one network cards on the PC, observe the information
contained in chapter 'IP settings for several network cards [➙ 28]'.
The table below shows which data is overwritten in the 'Station'.
Command
Overwrites the
↑ BDV
Sets the address
of the 'Station'
Overwrites the
configuration
'Initialize station'
1
Yes Yes Yes
'Download site' Yes No Yes
2
1
Command is only performed for the 'Station' that is connected to the PC via LAN.
2
The configuration of selected 'Stations' or all 'Stations' in the ↑ 'Site' can be
overwritten as an option.
See also
2 Initializing the station [➙ 106]
7.5 Initializing the station
● Each ↑ 'Station' in a system with several networked 'Stations' must have a
unique address.
● Once a 'Station' has been started for the first time or once the firmware on the
main CPU has been updated, a 'Station' has the address '1'. Networked
'Stations' must therefore all be initialized.
● If two 'Sites' are merged to form one ↑ 'Site', the 'Stations' with the same
addresses in the added 'Site' must each be given a new address.
● The 'Initialize station' procedure issues the 'Station' an address within the 'Site'
according to the configuration in Cerberus-Engineering-Tool.
' does not have to be initialized.
If you use more than one network cards on the PC, observe the information
contained in chapter 'IP settings for several network cards [➙ 28]'.
You will find a detailed description for initialization of a '
'A6V10210416'. See chapter 'Applicable documents'.
See also
2 Loading configuration from the PC to the station [➙ 107]
2 Load data to the station [➙ 106]
2 Applicable documents [➙ 13]
To Next Page
Loading...
