Siemens FS720 - Setting Network Speed for SAFEDLINK; Configuring Remote Access with Two Gaps

'Network' task card
Network configuration
14
319 |
412
Building Technologies
A6V10210424_j_en_
--
Fire Safety
2018
-
08
-
29
14.2.7 Setting network speed for SAFEDLINK
The network speed is set to the 'Standard' setting for high cable quality. If using
lower cable quality or if problems arise with long cables, the 'Low' speed must be
set.
Figure 147: 'SAFEDLINK sub-net' detail editor
To set the network speed, proceed as follows:
1. Open the 'Global system configuration' > 'FS720 network configuration' >
'Ethernet sub-net' elements in the tree view of the 'Network' task card.
2. Highlight 'SAFEDLINK sub-net'.
3. Select setting 'Low' for 'Network speed' in the detail editor.
a The network speed is set for low cable qualities.
14.2.8 Configuring remote access with two GAPs
You will find additional information about the individual steps on the specified
pages.
1. Configure one ↑ 'Station' as 'GAP' and one 'Station' as 'Secondary GAP'. Link
[➙ 314]
2. Configure the ↑ GAP 'Station' with DHCP server. Link [➙ 315]
3. In 'GAP', create a 'Route' element and enter the following values. Link [➙ 317]
– 'Destination address': Sub-net of ↑ management station A – 10.169.29.0
– 'Netmask': 255.255.255.0
– ↑ 'Gateway': Address of 'Security module (firewall)' A – 192.168.100.10