Siemens FS720 - Installation Via the Input Prompt; Installation and Uninstallation with Default Parameter Values

Installation
Installation via the input prompt
3
29 |
412
Building Technologies
A6V10210424_j_en_
--
Fire Safety
2018
-
08
-
29
3.6 Installation via the input prompt
Installation via the Command Prompt automatically uninstalls earlier engineering
tool set versions and installs the required version automatically. When installing via
the Command Prompt, no installation routine is executed, i.e., no dialog windows
are displayed that guide you through the installation.
NOTICE
Data will be deleted
Installation via the Command Prompt automatically uninstalls earlier installations
of the engineering tool set. This may lead to data being deleted, e.g., BDVs.
● Take the default uninstall parameters into account and change the parameter
values to prevent data being deleted.
The
uninstall and installation process cannot be interrupted.
Installation via the input prompt is supported from engineering tool set version
4.0.0. Older versions have to be uninstalled manually.
The instructions below apply to installation in
Windows
7 and 8.1.
3.6.1 Installation and uninstallation with default parameter values
The tables below display the default parameters.
Installation parameter Default value
Installation path
C:\Program Files (x86)\Siemens\F-
FX7230\XS_en_x-Vx.x
Data path C:\ProgramData\Siemens\F-FX7230
Engineering Tool interface language on
initial start-up
English
BDV language on initial start-up English
Launch Engineering Tool after
installation
Yes
Uninstallation parameter Default value
Remove BDVs Yes
Remove additional documents No
Remove firmware packages No
Remove site configurations No
Remove reports No
Remove proposed input texts No
Remove site property templates No