extinguishing control group
16
353 |
Building Technologies
16.4 Configuring an extinguishing control group
The 'Extinguishing control group' element is a superordinate control element for the
flooding zone. The flooding zone is summarized in an 'Extinguishing sector control'
element.
Creating and configuring the 'Extinguishing control group'
The sequence only contains the necessary configuration ste
information about the elements that can be assigned or created, as well as the
parameters, in separate sections further down in this chapter.
w A 'Station' element is created.
1. Create the a 'Extinguishing control group' element in the 'Control' task card for
the 'Station' element.
2. Enter the required customer text in the 'Overview' tab.
3. Configure the 'Extinguishing control group' element in the 'Details' tab.
'Extinguishing control group' – parameters in the 'Details' tab
Parameters Values Description
'Control test allowed' On/off
When the parameter is active, the 'Extinguishing
control group' can be set to the test status with a
control command.
The 'Extinguishing control group' element can contain the following elements:
● 'Extinguishing sector control'
To Next Page
Loading...
