Siemens FS720 - I;O Cards

'Hardware' task card
I/O card
s
10
135 |
412
Building Technologies
A6V10210424_j_en_
--
Fire Safety
2018
-
08
-
29
Operation mode
'Mains
supervision
enabled'
'Battery
supervision
enabled'
'Converter
supervision
enabled'
Display delay
'Emergency
power delay',
'Enabled'
With battery
backup
√ √ √ √ or –
Without battery
backup
√ – √ –
With an external
DC power supply
unit
– – – –
With redundant
supply
√ √ – √ or –
Table 4: Configuration of the power supply
√ Checkbox checked
– Checkbox unchecked
You will find the hardware configuration in document A6V10210416. See chapter
'Applicable documents'.
See also
2 Applicable documents [➙ 13]
10.5 I/O cards
I/O card (programmable) FCI2008-A1
The I/O card (programmable) FCI2008-A1 has 12 programmable inputs / outputs.
I/O card (remote transmission) FCI2007-A1
The I/O card (remote transmission) FCI2007-A1 has eight inputs / outputs for alarm
and fault transmission.
I/O card (horn/monitored) FCI2009-A1
The I/O card (horn / monitored) FCI2009-A1 has eight monitored outputs for alarm
and fault transmission.
You will find additional information on the I/O cards in document
A6V10210368
.
See chapter 'Applicable documents'.
Create I/O card
1. Select 'Hardware' > ↑ 'Station' in the task card.
2. Create the I/O card for the 'Station'. Link [➙ 68]