13
292 | 412
13.5.3 Configuring mimic display driver FT2001
Figure 127: 'LEDs/outputs' detail editor
In the detail editor the following properties can be set:
● 'Suppress LED test, connector 1', 'Suppress LED test, connector 2'
Blocks the triggering of an LED test of the outputs on connection 1 or 2 via the
local input.
● 'Output mode, connector 1', 'Output mode, connector 2'
Active mode of outputs connected to connection 1 or 2:
– 'LEDs, bright mode'
– 'LEDs, dimmed mode'
– 'Relays'
See also
2 Element 'LED ind./mimic 48 LEDs' [➙ 290]
13.6 Event printer
The event printer logs all ↑ site events from its configured ↑ visibility.
An internal or external event printer is connected to a ↑ 'Station' via the RS232 and
RS845 interfaces. These interfaces are read in when the Station is powered up.
You will find a description of
the commissioning of the external Fujitsu DL3750+
printer in document A6V10224853. See chapter 'Applicable documents'.
Depending on the printer used, the following elements must be created in the
'Operation' task card and assigned to the hardware:
● 'Built-in printer'
● 'External printer'
Pre-configuring element printer
To create the 'Built-in printer' or 'External printer' element, proceed as follows:
1. Select 'Operation' > 'Station' in the task card, along with the interface to which
the printer is connected.
2. Create the 'Built-in printer' or 'External printer' element for the 'Station'. Link
[➙ 68]
Once the hardware has been read in and is loaded to Cerberus-Engineering-Tool,
the element has to be assigned to the hardware using the Assign function.
To Next Page
Loading...
