LED indicator FTO2002 and mimic display driver FT2001
13
291 |
Building Technologies
Setting properties
Figure 125: 'LED ind./mimic 48 LEDs', 'Overview' detail editor
● 'Supply supervision enabled': Defines whether a local supply is present which
is to be monitored.
Figure 126: 'Visibility', 'Overview' detail editor
In the detail editor of the 'Visibility' element, the following properties can be set:
● 'LED mode': Defines the mode of the LED in active or inactive status,
respectively.
● 'Threshold': Defines how many events from the defined event category need to
be active at the same time in the assigned element or its subtree for the cause
to be considered active by the control.
● 'ACTIVE if no communication to source': Defines the cause's default status
(active or quiet) should communication be interrupted to the ↑ station where
the referenced element is stored.
To Next Page
Loading...
