Siemens FS720 - Setting up a Maximum Transmission Unit (MTU)

'Network' task card
Setting up a Maximum Transmission Unit (MTU)
14
328 | 412
Building Technologies
A6V10210424_j_en_
--
Fire Safety
2018
-
08
-
29
● For Cerberus-Remote
– 'Cerberus-Remote' > 'Connect'
The 'Connect' window is opened when a command is performed.
14.4 Setting up a Maximum Transmission Unit (MTU)
The default setting for the MTU size is 1500 bytes. If a FW update fails, you can
set lower values and apply them optionally for the 'Connection to IP address'.
The defined MTU size must be applied for remote access via
cRSP.
Set the MTU as shown below:
Figure 148: Maximum Transmission Unit (MTU)
This setting can be selected optionally for a 'Connection to IP address'.
Figure 149: Maximum Transmission Unit (MTU) 02