Siemens FS720 - Page 183

'Control' task card
Universal control group
12
183 |
412
Building Technologies
A6V10210424_j_en_
--
Fire Safety
2018
-
08
-
29
6. Select the element you want.
7. Click on 'Assign'.
a The element is assigned to 'Causes'.
Assigning effects
Two trees, one above the other, are visible in the figure below. The lower tree
appears only when a confirmation input can be assigned.
To assign an ↑ effect, proceed as follows:
1. Select the 'Control' task card.
2. Open 'Station' > 'Fire control group' > 'Fire control' in the tree view.
3. Highlight the element 'Effects'.
4. In the toolbar, click on 'Assign'.
a The 'New effect dialog' window opens.
5. Select an output or command on the left in the window.
a The appropriate tree is shown in the right side of the window. The elements
that can be assigned are highlighted.
6. Select the element you want.
7. Click on 'Assign'.
a The element is assigned to 'Effects'.