Person Machine Interface (PMI)
13
273 |
Building Technologies
13.2.6.1 Configuring standard key for the toggle function
Configuring the command
Figure 103: Assigning a standard key to a command and an element
1. Select the 'Operation' task card.
2. Open ↑ 'Station' > 'PMI' > 'Standard keys' in the tree view.
3. Highlight a 'Key' element.
4. In the menu bar, click on 'Assign'.
a The 'New effect dialog' window opens.
5. Select a command on the left in the window e.g. 'Detector test'.
6. On the right in the window, select an element, e.g., a 'Zone' from the
↑ 'Detection tree'.
7. Click on 'Assign'.
a The 'Key' is assigned to the command and the element.
a The command is displayed under the 'Key' in the tree view.
To Next Page
Loading...
